![Huge fill gaps nozzle 1mm lh0.8 infill 100% slicer cura ,is my esteps wrong or what , printer anet a8 marlin 2 brims was good but print it self bad : r/FixMyPrint Huge fill gaps nozzle 1mm lh0.8 infill 100% slicer cura ,is my esteps wrong or what , printer anet a8 marlin 2 brims was good but print it self bad : r/FixMyPrint](https://i.redd.it/qm0wa5d2dsvb1.jpg)
Huge fill gaps nozzle 1mm lh0.8 infill 100% slicer cura ,is my esteps wrong or what , printer anet a8 marlin 2 brims was good but print it self bad : r/FixMyPrint
![Small corners with infill not printing properly on my Anet A8 (slicer: Cura, layer height: 0.2, infill: 20%, generic PLA settings with Hatchbox PLA). Any idea what can be causing this? : r/3Dprinting Small corners with infill not printing properly on my Anet A8 (slicer: Cura, layer height: 0.2, infill: 20%, generic PLA settings with Hatchbox PLA). Any idea what can be causing this? : r/3Dprinting](https://i.redd.it/lj9kmdg1lao11.jpg)
Small corners with infill not printing properly on my Anet A8 (slicer: Cura, layer height: 0.2, infill: 20%, generic PLA settings with Hatchbox PLA). Any idea what can be causing this? : r/3Dprinting
![Getting Started With Airwolf 3D Printer Slic3r Configurations | 3D Printer Manufacturers - Airwolf 3D Getting Started With Airwolf 3D Printer Slic3r Configurations | 3D Printer Manufacturers - Airwolf 3D](https://airwolf3d.com/wp-content/uploads/2012/08/3D-Printer-Slic3r-Configurations-load.jpg)